Configuration

 

The Configure button is available in both Player and Cue Editor

 

 

 

In the Player mode using the Configure button, you can change the port settings for the serial output, change output settings and channel labels. Tools button allows changing password and to adjust sceensaver settings.

 

 

 

The Port button allows for configuration of the serial RS232 port. The Cue send spacing, adjusts the minimum time between cues sent to port. This may need to be increased for slower computers to avoid missing cues. DMX512 spacing adjusts the repeat speed to the USB port. The Step spacing adjusts the time for each step when fading in or out; 30ms = 33 steps per second. This also may need to be increased for slower computers. The Cue resolution, how close cues can be programmed to each other, can be optimized for your computer's output capabilities.

 

The Output setup button is explained in the Driver Help area.

 

 

The Channel setup window allows changing Channel and Zone labels. Zones are user definable groups of relay/dimmers. Relay mode is an on/off function only, Dimmer mode will allow variable value and fade functions. It should be noted that A/C pumps and motors should always be set to relay mode.

 

 

Channels can be moved up or down, if the first channel in the first Zone is moved up a new Zone will be created. If the last channel in the last Zone is moved down a new Zone will be created. Channel positions can be "stacked" in any order. This is like a patch bay to make programming faster no matter how the pumps and lights are plugged in at the devices being controlled.

 

Password modification or enable/disable is accessible in Tools.

 

Set screen saver button allows for enable/disable and wait time for screen saver function.